Lighted Enclosure for the iPad Mini, with 15 Degree Bracket and Side Mount

Lighted Enclosure for the iPad Mini, with 0 Degree Bracket and Surface Mount

Slim Enclosure for the iPad Mini, with 15 Degree Bracket and Rear-offset Mount.

This document shows where the light frequency setting is located in the Zoom dashboard.

Change the color of the light easily by simply entering the corresponding frequency into the application used to control the tablets (Envoy, Zoom, EMS Software, EventBoard, etc.)

These frequencies can be tested by opening the link below directly from the tablet in the VisualTarget enclosure:
magtarget.com/color

Updated in February 2019 to integrate dimmer LED brightness,
new LED off frequency, rainbow frequency for trade shows.
Legacy frequency is still supported.
If you received a new enclosure prior to February 2018 contact our technical support team to obtain your corresponding Frequency Key

Guided instructions on how to install the various VisualTarget mounts as well as the install of the tablets in the enclosures.
***NOTE: VisualTarget Enclosures do not support off-the-shelf RJ-45 connectors that have a rubber strain relief after the connector. The cable must be terminated with a standard RJ-45 plug.

These are instructions on how to change the electronic housing (aka electronic box) on the back of an enclosure to a new electronic box.

This guide takes the guess work out of drilling mounting holes in the right place. Simply print at full scale and place on the mounting area.

KRONOS Enclosures do not support off-the-shelf RJ-45 connectors that have a rubber strain relief after the connector. The cable must be terminated with a standard RJ-45 plug.
The instructions show how a cable with molded strain relief can be upgraded to a standard RJ-45 connector.

Although the steps below are specific to Cisco PoE Switches (running IOS) with EventBoard from TEEM installed on the tablets. Similar steps can be taken to setup other switches and mobile App.